Dubans Construction Chemical

Integral waterproofing admixture based

on crystalline formation to produce water

tight concrete.

Uses

Conplast Crystalline is an integral waterproofi ng admixture to

produce water tight concrete. The active chemical in Conplast

Crystalline react with moisture available in concrete to produce

non soluble crystalline formation throughout the pores of capillary

tracks thus making concrete permanently sealed against

water penetration from any direction.

Conplast Crystalline is developed to use in

 All types of concrete foundation below ground

 Water reservoir

 Tunnel Concreting

 Retaining walls and subways

 Water tank and Swimming pools

 Precast unit

Advantages

 Easy to use, require only mixing with concrete.

 Integral waterproofi ng system.

 Crack fi lling property with time up to 0.4mm width

 Exhibits good resistance to hydrostatic water pressure

both surface.

 Compatible with our full range of water reducing

admixture.

 More effective due to formation of crystalline in tiny

capillaries.

 Reduce Shrinkage and Creep

 Increase Durability

Description

Conplast Crystalline is a powder form with perfect blend of

Portland cement with other ingredients. Crystalline chemicals

react with water in concrete to form crystals structure in the

tiny capillaries. These insoluble crystals structure that clogs

the pores. This process continues until all the chemicals have

 

reacted.

General purpose, non-shrink, cementitiousmicroconcrete .UsesFor repairs to damaged reinforced concrete elements, particularlywhere access is restricted and where vibration of theplaced material is diffi cult or impossible. Suitable for variousstructural strengthening measures such as encasement buildups,etc.AdvantagesGaseous expansion system compensates for shrinkageand settlement in the plastic state. Can be pumped or poured into restricted locations. Highly fl uid to allow for placement without vibration. Pre-packed to overcome site-batched variations. Rapid strength gain to facilitate early reinstatement High ultimate strengths and low permeability of cured repair. Contains no chloride admixture.DescriptionRenderoc RG(S) is supplied as a ready to use blend of drypowders which requires only the site addition of clean water toproduce a free-fl owing non-shrink repair micro concrete. Thematerial is based on Portland cements, graded aggregatesand fi llers, and additives which impart controlled expansioncharacteristics in the plastic state, while minimising water demand.The low water requirement ensures high early strengthand long-term durability.For larger repairs, the mixed Renderoc RG(S) may be modified by the addition of 5mm to 12mm clean, graded, saturatedsurface dry aggregates at site. For exceptionally large repairs,the local Fosroc offi ce should be consulted

Single component acrylic polymer for cementbased waterproof composite coatingmembraneUsesProvides an effective and economical method of waterproofi ngto concrete and masonry surfaces, by mixing with cement andapplication by brush.AdvantagesNon - toxic, non-fl ammable and user friendlyProvides a tough, impermeable waterproof membraneCan be applied by brush, on horizontal and vertical surfacesExcellent adhesion to concrete and masonry surfacesProtects concrete and mortar from natural elements suchas wind, rain, sunlightBreathable - allows inside water vapour to escapeDescriptionHydroproof Xtra is formulated to be mixed with cement on siteor simply brush applied over concrete or masonry surfaces toprovide an effective waterproof membrane.